Anzahl | Stückpreis |
---|---|
Bis 2 |
290,00 €*
|
Bis 4 |
287,00 €*
|
Bis 6 |
284,00 €*
|
Ab 7 |
282,00 €*
|
Versandfertig in 2 Tagen, Lieferzeit 2-5 Arbeitstage
The most extended bass, lowest distortion and best control is usually realized in properly designed vented enclosures. Typical enclosure sizes range from 80lit. up with tunings from 40 to 50Hz.
Low-frequency equalization is suggested in order to improve the bass output. A conservative idea of amplifier size ranges from 400-800W, allowing maximum output with no risk of speaker damage when properly used.
The neodymium magnet assembly assures high flux concentration, low power compression and excellent heat exchange, since the external magnet configuration is considerably more efficient than the traditional under-pole magnet topology. This allows to obtain high levels of force factor and power handling with a power to
weight ratio at the upper level of the category.
SDR (Single Demodulating Ring) technology has been used to reproduce instantaneous peaks on mid frequencies, reducing intermodulation distortion.
The high quality paper cone has a smooth, curvilinear profile design that eliminates bell-mode resonances within the intended frequency range. This is carried by a specially treated and damped multiple roll linen suspension designed to control excursion maintaining the piston action linearity.
The 15NMB420 employs a 75mm aluminum Interleaved Sandwich Voice coil (ISV), in which a high strength fiberglass former carries windings on both the outer and inner surfaces to achieve a mass balanced coil, resulting in an extremely linear motor assembly.
Coaxial: | NEIN |
---|---|
Größe: | 15" |
Impedanz: | 8 Ohm |
Magnet: | Neodym |
Qts: | 0,26 - 0,30 |
Sperrgut: | NEIN |
X-MAX: | 5,1 - 10,0 mm |
Anmelden
DIY DATENBANK 4.0 - EINFACH GENIAL
Wer kennt nicht das Problem - man benötigt einen speziellen Typ Lautsprecherchassis und durchsucht stundenlang das Web. Hinter dem Shopsystem von mobile-club-sounds verbirgt sich eine DATENBANK die Dir hierbei Abhilfe in Sekunden bringt.
In der Überkategorie "Chassis & Hörner" kannst Du Treiber nach vordefinierten Qts-Gruppen sortieren. So selektierst Du Treiber für beispielsweise ein Horn oder eine Transmisionline. Du wählst ob Du einen Low-Mid-Treiber suchst der eher "warm" oder "direkt" klingt. Im Anschluss kann die Größe, die Impedanz und der X-MAX gewählt werden um eine ideale Eingrenzung der Parameter zu gewährleisten. Auch eine Definition Deines Budgets ist möglich. So entsteht eine Hersteller übergreifende Auswahl nach Deinen Anforderungen.
Natürlich ist diese Selektion auch auf Parameter anderer Kategorien wie Endstufen, Controller, Movinglights u.s.w. anwendbar.
Sollten dennoch Fragen offen bleiben, so können diese gerne in einer telefonischen Beratung geklärt werden.
